MacDon A40-D, Operator'S Manual

Page: 175 / 240

214804
161
Revision A
4.9.5 Replacing Tine: Tine Bar Extension
–
Section Z
Figure 4.116: Tine Bar Extension
–
Section Z
A - Disc #3 B - Disc #4
Y - Section Y Z - Section Z
Replace tine and bearings at center section Z (Z) as follows:
Figure 4.117: Disc #4
A - Bolt B - Keepers
Z - Section Z
1. Remove bolt (A) and keepers (B) on tine to be replaced,
and slide tines off tine bar.
Figure 4.118: End View of Tine Bar
2. Install tines on tine bar, and secure with bolt (A) and two
keepers (B). Tine (C) must be clamped between
keepers (B). Install nut with flat side against tine bar
extension.
MAINTENANCE AND SERVICING