LS ELECTRIC SV-iS7 Series, User Manual

Page: 178 / 491

Basic Functions
161
B
as
ic
Func
tio
ns
Group Code Name LCD Display Parameter Setting Setting Range Unit
CNF 42 [MULTI] key
functions Multi-Key Sel 2 Local/Remote -
-
DRV 06 Command source Cmd Source 1 Fx/Rx-1 0 – 5 -
Local/Remote Mode Switching Setting Details
Code Description
CNF-42
[MULTI] key
functions
Set CNF-42 to “ 2(Local/Remote) ” to perform local/remote mode switching
using the [MULTI] key.
Once the parameter is set,
“R” (remote) is displayed on the keypad, and the
inverter will automatically begin operating in remote mode. Changing from
local to remote operation will not alter any previously configured parameter
values and the operation of the inverter will not change.
Press the [MULTI] key to switch the operation mode to
“ local. ”
“ L ” (local) is displayed on the keypad, and the command source and frequency
source indication on the keypad (in MON mode) changes to “ K/K. ”
The inverter stops operating if it was previously running in remote mode, and
you can operate the inverter using the keypad.
Press the [MULTI] key again to switch the operation mode back to
“ remote. ”
“R” (remote) is displayed again on the keypad, and the command source and
frequency source indication on the keypad (in MON mode) changes according
to the previous parameter settings.
The inverter is now ready to operate in remote mode, and the inverter
operation may vary depending on the type of input source.
Note
Local/Remote Operation
• Full control of the inverter is available with the keypad during local operation.
• During local operation, jog commands will only work if one of the multi-function terminals (Px:
P1
–
P11, codes IN-65 – 75) is set to “ 1 3 (RUN Enable)” and the relevant terminal is turned on.
• During remote operation, the inverter will operate according to the previously set frequency
reference source and the command received from the input device.
• If ADV-10 (power-on run) is set to “ 0 (No)” , the inverter will not operate on power-on even when
the following terminals are turned on:
- Fwd/Rev run (Fx/Rx) terminal
- Fwd/Rev jog terminal (Fwd jog/Rev Jog)