LS ELECTRIC SV-iS7 Series, User Manual

Page: 101 / 491

Connecting the Cables
84
Note
• Before setting the parameter values for a user application, initialize the parameter settings to
make sure that the default setting is applied to all parameters.
• If you initialized all parameters after an inverter trip occurred, the inverter starts in Easy Start
mode after it is reset, regardless of the pending trip condition.
• Easy Start mode is not available while the inverter is already running.
4.18.2 Setting the Basic Parameters in Easy Start Mode
Refer to the following sequence table to understand the Easy Start sequence and configure the
basic parameters according to the instructions.
Sequence Instruction
Start Easy Set
Select “ Yes ” to start the inverter in Easy Start mode (select “ No ” to start
the inverter in Monitor mode).
CNF-01 Language Sel
Select the keypad display language (only English is available at the
moment).
DRV-14 Motor Capacity Set the motor capacity. (Ex: 0.75 kW, 1.5 kW)
BAS-11 Pole Number Set the number of poles in the motor.
BAS-15 Rated Volt
Set the rated motor voltage. Set this value to “ 0 V ” if the rated motor
voltage is identical to the input voltage.
BAS-10 60/50 Hz Sel Set the rated motor frequency.
BAS19 AC Input Volt Set the inverter input voltage.
DRV-06 Cmd Source
Set the source of the frequency reference. (Ex: KEYPAD, FX/RX-1, FX/RX-
2, etc.)
DRV-01 Cmd Frequency Set the frequency reference. (Ex: 50 Hz, 60 Hz, etc.)
Note
While you are in Easy Start mode, you can press the [ESC] key on the keypad to cancel Easy Start
mode and enter Monitor mode.