Leica GR10, Operational Manual

Page: 57 / 317

Printed Documentation
Install USB drivers for Windows 7 operating systems
Follow these steps to install drivers for Windows 7 operating systems for the first time:
Step Description
1
Turn on the GR10.
2
Start the computer.
3
Disable the User Account Control before installing the drivers.
4
Go to
Start
/
Control Panel
/
User Accounts and Family Safety
(or
User Accounts
, if you are
connected to a network domain) /
User Accoun
.
ts
5
Go to
Change User Account Control
settings.
6
Select level
Never notify
and click
OK
.
7
Confirm the change by clicking on
Yes
when asked to allow the change.
8
Restart the computer for all changes to take effect. (Not needed if UAC is already disabled.)
9
Insert the Leica GR10 DVD.
10
Run the installer executable depending on your CPU and operating system to install the drivers
necessary for your GR10.
•
32 bit CPU: SetupViva&GR_USB_32bit.exe
•
64 bit CPU: SetupViva&GR_USB_64bit.exe
•
Itanium 64 bit CPU: SetupViva&GR_USB_64bit_itanium.exe
11
Wait until the Mobile Device Center Driver Update is finished.
12
The
Welcom to the InstallShield Wizard
for Leica Viva & GR USB drivers window appears.
e
13
Click
Next
>.
14
The
Ready to Install the Program
window appears.
15
Click Install. The drivers will be installed on your computer.
16
Click
Continue Anyway
every time a window pops up saying that the software has not passed
the Windows Logo testing.
17
The
InstallShield Wizard Completed
window appears.
18
Read the instructions and check the box,
I have read the instructions
. These instructions are
listed in detail in the following steps.
19
Click Finish to exit the wizard.
20
Loosen the screw on the SD card/USB port cover.
21
Open the SD card/USB port cover.
22
Plug the USB cable into the USB port on the GR10.
23
Plug the USB cable into the USB port of the computer.
Windows will show searching for IP address. Ignore this and go to the next step.
24
Run shortcut Configure GR connection which has been created on the Windows desktop.
There are two more shortcuts created for the GS and CS. These shortcuts can be ignored, unless
these devices will be used on this computer. Refer to the GS/CS User Manual for further
information.
25
A DOS window is opened and a batch file is started to configure the IP settings for the RNDIS
network adapter.
26
Press any key to close the DOS window.
56