Kyocera Ai5555, Instruction Handbook Manual

Page: 38 / 167

NetWare Configuration 3-17
NetWare Configuration
Using the Network Management Utility
Using Help Screens
Protocols
Setup NetWare
The following information explains how you can change each field or make
entries on the NetWare Configuration Menu.
Enable NetWare
When checked, Novell NetWare is enabled as a protocol for the print server.
If Novell NetWare is a permanent protocol, then the box cannot be un-
checked. For print servers where Novell NetWare is not the primary
protocol, click this box to either enable or disable the protocol.
Print Server Name
Each Novell print server has a unique name assigned to it. The print server
uses the default name of NC2_(serial_number). The serial number is located
on a label attached to the NC-2 board.
If you want to change the default name or the existing name, enter the new
print server name in this field. The name can be up to 63 characters in
length. You must also remember to change the name in PCONSOLE;
otherwise the name change will not take effect.
Print Server Password
The network administrator assigns a password to the Novell print server.
When a password is assigned through NetWare's PCONSOLE, you need to
inform the print server of the assigned password.
When you enter the password in this field, make sure it is the same pass-
word that was assigned through PCONSOLE. The password is stored in the
print server configuration memory.
To assign a password to the print server in PCONSOLE, refer to your
Novell documentation. Using this program, first type in the password in the
Print Server Password field, then retype the password in the Password
Retype field. The password is the same for all file servers assigned to the
print server.
Password Retype
See above.