Bar type axle
(1) 540 N
⋅
m / 55.1 kgf
⋅
m
(2) 670 N
⋅
m / 68.3 kgf
⋅
m
(3) 350 N
⋅
m / 35.7 kgf
⋅
m
3. Checking tie-rod dust cover
Check to see that dust covers are not damaged.
If dust covers are damaged, consult your local
KUBOTA Dealer for this service.
(1) Dust cover
IMPORTANT :
• If dust covers are cracked, water and dust can
cause premature wear of the tie-rod.
4. Checking air brake for trailer (if
equipped)
Discharging condensation (water) from the air tank.
1. Push in the valve pin at the bottom of the air tank
and check if there is a pool of condensation inside.
WARNING
To avoid personal injury or death:
• When discharging condensation (water)
from the air tank, wear protective goggles to
guard your eyes against sand and dust
stirred up.
• Before doing the servicing, lower the
pressure in the air tank first.
(1) Air tank
(2) Valve pin
Inspecting the air connector
1. Check the sealing for damage and other
abnormalities.
Damaged sealing should be replaced in order to
avoid air leaks.
When not in use, keep the cap tight in position.
Check the following parts as well:
• Compressor drive belt for damage
• Compressor itself for oil leak
• Hoses for damage
EVERY 100 HOURS
1. Cleaning air cleaner primary
element
1. Unlatch and remove the housing service cover.
2. Push down on the service handle to tilt the primary
element to a 5° angle. This will loosen the seal.
3. Then, pull out on the service handle to remove the
primary element from the housing.
4. Clean the primary element:
When dry dust adheres to the element, blow
compressed air from the inside, turning the
element.
Pressure of compressed air must be under 205 kPa
(2.1 kgf/cm
2
, 30 psi).
5. Inspect the element:
Visually check for cuts, tears or indentations on the
sealing surfaces and the element before
installation. If any damage is visible, do not install.
PERIODIC SERVICE
EVERY 50 HOURS
266
M7132, M7152, M7172
Summary of Contents for M7-132
