Kubota M7-132, Operator'S Manual

Page: 212 / 332

off. It is useful if the load of an attached implement is
not symmetrical or the work is done on a slope.
(1) Lower link
(2) Lock bolt (not an accessory)
TYPE A (HITCH MADE BY
SCHARMÜLLER)
1. Drawbar
WARNING
To avoid personal injury or death:
• Never pull from the top link, the rear axle or any
point above the drawbar. Doing so could cause
the tractor to tip over rearward causing
personal injury or death.
NOTE :
• For information about the drawbar load, read
the implement limitations section of this
manual.
(See IMPLEMENT LIMITATIONS on page 36.)
(1) Drawbar
(2) Locating pin
1.1 Swing drawbar
The drawbar can be used in 3 different ways as shown
in the following illustration. Assemble it correctly with
locating pins.
(1) Drawbar
(2) Locating pin
2. High-hitch
WARNING
To avoid personal injury or death:
• Never pull from the top link, the rear axle or any
point above the hitch. Doing so could cause the
tractor to tip over rearward causing personal
injury or death.
NOTE :
• For information about the high-hitch load, read
the implement limitations section of this
manual.
(See IMPLEMENT LIMITATIONS on page 36.)
The high-hitch can be adjusted depending on an
attachment to pull behind. The high-hitch may get in the
way when connecting the PTO shaft. In such case,
either set the high-hitch to its uppermost position or
remove it.
(1) Automatic clevis
(2) K80 ball with grab handle
3-POINT HITCH AND DRAWBAR TYPE A (HITCH MADE BY SCHARMÜLLER )
206
M7132, M7152, M7172