1.1 Main shift
With the ez-command centre, the machine can be
“sped up”
and
“slowed down”
easily.
Push the lever forward and pull it backward, and the
travelling
speed
will
increase
and
decrease
respectively. The travelling speed is fixed at the position
where you release the lever.
The travelling speed changes in proportion to the
duration of moving the lever. The longer the lever is
pushed forward, for instance, the higher the travelling
speed becomes.
(1) Ez-command centre
(A) “SPEED UP”
(B) “SLOW DOWN”
NOTE :
• The ez-command centre has no neutral
position. Even when the lever is set at the
lowest speed position, the machine runs at the
creep speed at about 0.5 km/h (0.3 mph). To
bring the tractor to a complete stop, step on the
brake pedal or set the shuttle lever to neutral.
• Allowing for conditions, use the “cruise mode”
when you want to make fine adjustments to the
travelling speed, or to keep the travelling speed
steady for a job with a high traction load on the
tractor.
(See Operation of the automatic mode on page
173.)
• When the ez-command center is pushed
forward during the tractor driving by using foot
throttle, the travelling speed is set at the time of
ez-command centre operation. But this setting
is effective for only when the tractor has a light
load.
1.2 Mode shift
Every time the mode shift button is pressed, the
“high
speed”
and
“low speed”
modes switch alternately.
Depending on this selection, the
“travelling enable
upper limit speed”
, shown with the LCD indicator on the
instrument panel, is also switched.
(1) Ez-command centre
(2) Mode shift button
(A) “PUSH”
(1) “Travelling enable upper limit speed”
NOTE :
• Switching from the high speed mode to the low
speed mode is not possible if the current
travelling speed is higher than the maximum
travelling speed set in the low speed mode; a
buzzer will sound if this is tried.
1.3 Modifying the maximum travelling
speed
Maximum travelling speed controlled with the ez-
command centre has been factory set as follows. The
mode shift’s
“low speed”
range alone can be modified
for its highest travelling speed.
Factory set travelling speeds
• Mode shift (low):
Maximum travelling speed up to 15 km/h (9 mph)
• Mode shift (high):
Maximum travelling speed up to 40-50 km/h (25-30
mph)
Modifying the low-range travelling speeds
Set the desired travelling speed while confirming its
digital display.
OPERATING THE TRACTOR
CONTINUOUSLY VARIABLE TRANSMISSION (CVT) CONTROL
172
M7132, M7152, M7172
Summary of Contents for M7-132
