Kubota M7-132, Operator'S Manual

Page: 294 / 332

5. Fill the transmission oil up to the upper line of the
sight glass.
(1) Filling plug
(1) Sight glass (A) Oil level is acceptable within
this range
6. After running the engine for a few minutes, stop the
engine, wait for 10 minutes and check the oil level
again, add oil to the prescribed level.
7. Make sure that the transmission fluid does not leak
past the seal on the filter.
NOTE :
• Check the transmission fluid level under the
following conditions:
a. Park the machine on a flat surface.
b. Lower the rear 3-point hitch and front
end loader (if equipped).
c. Raise the front 3-point hitch (if
equipped).
d. Disconnect all remote control valve
hoses.
e. Stop engine and wait for 10 minutes.
3. Changing rear axle case oil
WARNING
To avoid personal injury or death:
• Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug and
filling plug at the front axle case and drain the oil
completely into the oil pan.
2. After draining, reinstall the drain plug.
3. Fill with the new oil up to the lower rim of filling plug
port.
(See LUBRICANTS, FUEL AND COOLANT on
page 252.)
4. After filling, reinstall the filling plug.
Oil capacity 10 L for each side
(1) Drain plug
(2) Filling plug
4. Changing front differential case oil
1. To drain the used oil, remove the drain and filling
plug at the front differential case and drain the oil
completely into the oil pan.
2. After draining, reinstall the drain plug.
3. Fill with new oil up to the lower rim of filling plug
port.
(See LUBRICANTS, FUEL AND COOLANT on
page 252.)
PERIODIC SERVICE EVERY 1000 HOURS
288
M7132, M7152, M7172