Kubota M7-132, Operator'S Manual

Page: 285 / 332

2. Remove the oil filter.
Power shift transmission type
(1) Hydraulic oil filter
(2) O-ring
CVT type
(1) Hydraulic oil filter
(2) O-ring
3. Put a film of clean transmission oil on the rubber
seal of the new filter.
4. Tighten the filter quickly until it contacts the
mounting surface.
Tighten filter by hand an additional 1/2 turn only.
5. After the new filter has been replaced, fill the
transmission oil up to the upper limit of the sight
glass.
(1) Filling plug
(1) Sight glass (A) Oil level is acceptable within
this range
6. After running the engine for a few minutes, stop the
engine, wait for 10 minutes and check the oil level
again, add oil to the prescribed level.
7. Make sure that the transmission fluid doesn’t leak
past the seal on the filter.
IMPORTANT :
• To prevent serious damage to the hydraulic
system, use only a KUBOTA genuine filter.
NOTE :
• Check the transmission fluid level under the
following conditions:
a. Park the machine on a flat surface.
b. Lower the rear 3-point hitch and front
end loader (if equipped).
c. Raise the front 3-point hitch (if
equipped).
d. Disconnect all the remote control valve
hoses.
e. Shut off engine and wait for 10 minutes.
EVERY 500 HOURS PERIODIC SERVICE
M7132, M7152, M7172
279