4. Shuttle lever
WARNING
To avoid personal injury or death:
• When attempting to shift the shuttle shift lever
on a slope, be sure to completely stop the
tractor.
• Slow down the engine speed before shifting the
shuttle lever.
• Use the shuttle lever when the machine speed
is below 20 km/h (12.4 mph).
NOTE :
• If the previous warnings are not followed, the
clutch gets disengaged and the buzzer starts
sounding.
To get the clutch reengaged and clear the
buzzer, take either of the following steps.
– Place the shuttle lever back to the original
position.
– Decrease the machine speed lower than 20
km/h (12.4 mph) and use the shuttle lever.
Raise up and shift the shuttle shift lever forward to
obtain forward speeds and shift it backward to obtain
reverse speeds without using the clutch pedal.
Whether travelling or at a stop, push down the shuttle
lever and it will return to the neutral position.
(1) Shuttle lever
(F) “FORWARD”
(N) “NEUTRAL”
(R) “REVERSE”
NOTE :
• Operate the shuttle lever while sitting in the
operator’s seat. Otherwise, the clutch will not
be engaged.
• While the shuttle shift lever or shuttle neutral
button is at the “NEUTRAL” position, the “N”
character appears on the LCD monitor.
• When you release the shuttle lever after shifting
to (F), (R), or (N) positions, the shuttle lever will
always return to its original position (see the
previous figure).
• If the shuttle lever is held at the (F), (R), or (N)
positions for approximately 5 to 10 seconds,
gear shifting will be cancelled and a message
will be displayed on the LCD monitor. If the
message is displayed, turn the key switch OFF
and then operate the shuttle lever again.
• When shuttle operation is done just after the
engine starting, the system is sometimes
judges this as an operational error. Shuttle
operation will cease to function. If this case
occurs, please handle it with the following
instruction.
– For power shift model:
If the shuttle operation does not function
with error message indicated, please stop
an engine once and re-start.
– For CVT model:
If the shuttle operation does not function,
please push down the shuttle lever to set
neutral, then start operation.
(1) “NEUTRAL”
(1) Message
(2) Error display (power shift transmission)
5. Shuttle button
Hold down the shuttle enable button and press the
shuttle button to switch forward and reverse travel.
TRAVEL CONTROLS
OPERATING THE TRACTOR
M7132, M7152, M7172
157
Summary of Contents for M7-132
