Kubota M7-132, Operator'S Manual

Page: 265 / 332

• Do not remove the radiator cap while the
coolant is hot. When cool, slowly rotate the cap
to the first stop and allow sufficient time for
excess pressure to escape before removing the
cap completely.
1. Check to see that the coolant level is between the
[MAX] and [MIN] marks of recovery tank.
2. When the coolant level drops due to evaporation,
add soft water only up to the max level.
In case of leakage, add antifreeze and soft water in
the specified mixing ratio up to the max level.
(See Flushing cooling system and changing coolant
on page 290.)
(1) Recovery tank
(2) Radiator cap (A) [MAX]
(B) [MIN]
IMPORTANT :
• If the radiator cap has to be removed, follow
the previous caution and securely retighten
the cap.
• Use clean, fresh soft water and antifreeze to
fill the radiator.
• If coolant should leak, consult your local
KUBOTA Dealer.
10. Cleaning grill, radiator and cooler
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before checking and
cleaning.
• The condenser and receiver become hot while
the air conditioner is running. Before checking
or cleaning them, wait long enough until they
cool down.
Radiator and cooler locations
(1) Radiator
(2) Intercooler
(3) Oil cooler
(4) Fuel cooler
(5) Air conditioner condenser
(6) Front PTO cooler (if equipped)
(7) Latch
Opening the cooler and condenser pack
1. Undo the latches on both sides.
2. Hold the handle and open the cooler and
condenser pack forward.
3. When the pack has been closed, be sure to lock the
latches on both sides.
(1) Cooler and condenser pack
(2) Latch
(3) Handle
Cleaning
1. Check front grill to be sure it is clean from debris.
DAILY CHECK PERIODIC SERVICE
M7132, M7152, M7172
259