Kubota M7-132, Operator'S Manual

Page: 217 / 332

(1) Front 3-point hitch control
switch
(6-gang remote control
valves type)
(2) Front 3-point hitch control
switch
(5-gang remote control
valves type)
(A) “RAISE”
(B) “LOWER”
(C) “NEUTRAL”
(D) “FLOAT”
2. Switching of the hydraulic valve
Using the 2 selector levers, the hydraulic circuit can be
switched to the
“single-acting” , “double-acting” or “lock”
mode.
Switch to the circuit suited for the implement. Incorrect
selection may damage the implement.
(1) Selector valve lever 1
(2) Selector valve lever 2 (A) “SINGLE-ACTING”
(B) “DOUBLE-ACTING”
(C) “LOCK”
NOTE :
• For the selector valve lever 1, pull out its
turning part outward and turn the lever.
Single-acting:
The lower link is hydraulically raised but lowered by its
own weight.
This mode is used for mowers, cultivators and others.
Double-acting:
The lower link is hydraulically raised and lowered.
This mode is used for snow removal with a front blade
and other similar applications.
Lock:
The hydraulic circuit to the implement is cut off.
This mode is used for travelling on public roads and
when the front 3-point hitch is not used.
3. Lower link
The lower link is foldable. Set it correctly according to
the relevant work.
(1) Lower link
(2) Lock pin (A) “GENERAL WORK”
(B) “FLOATING WORK”
(C) “TRANSPORT and STOR-
AGE”
For general works:
Put the pin into the position shown below, and fix the
lower link.
For floating works:
When the pin is placed in the position below, the lower
link is movable up and down by about 90 mm (3.54 in).
For transport and storage:
Put the pin into the position shown below, and retract
the cylinders completely.
FRONT 3-POINT HITCH (IF EQUIPPED) 3-POINT HITCH AND DRAWBAR
M7132, M7152, M7172
211