Kubota M7-132, Operator'S Manual

Page: 211 / 332

9.2 Adjusting lower link width
1. Set the width (W1) of lower links to be the same as
width (W2) of the implement.
Details regarding the adjustment of the width (W1)
of the lower links can be found in a different section.
(See Stabiliser (if equipped) on page 203.)
(1) Lower link
(2) Stabiliser
(3) Implement
9.3 Attaching implement to tractor
1. Set the release lever on the quick hitches to
“LOCK” position, if its lever is in “UNLOCK” position
(self-locking latches are closed).
2. With the lower links fully lowered, reverse the
tractor until the quick hitches are beneath the
implement ball-joints.
3. Raise the lower links using the hydraulic control
lever until the quick hitches engage the ball-joints.
NOTE :
• An audible click will be heard as the self-
locking latches engage the implement ball-
joint.
4. Lower the top link hook onto the upper implement
ball-joint and press down until the latch is engaged.
If necessary, adjust the top link length.
NOTE :
• The hook of a top link is attached in a
downward direction.
(1) Top link
(2) Lower link
(3) Latch
(4) Release lever (A) “LOCK” position
(B) “UNLOCK” position
9.4 Detaching implement from tractor
1. Fully lower the implement to the ground.
Support the implement with parking stand (if
equipped). If necessary, adjust the top link and or
lifting rod length so that the implement may stabilise
on the ground.
2. Pull the release lever on the top link to release the
hook from implement ball-joint.
Hook the top link in the top link support.
3. Pull the release levers on both lower links to the
unlocked position to release the quick hitches from
implement ball-joints.
The latches will disengage and allow the lower links
to lower and detach from the implement.
9.5 Quick hitch locking device
The lock bolt can be applied so that the “LATCH” does
not accidentally open and the implement does not fall
THE 3-POINT HITCH SETUP 3-POINT HITCH AND DRAWBAR
M7132, M7152, M7172
205