Kubota M7-132, Operator'S Manual

Page: 296 / 332

2. If hoses and clamps are found worn or damaged,
replace or repair them at once.
(1) DEF/AdBlue
®
lines
(2) Clamp bands
4. Replacing oil separator element
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before replacing the
oil separator element.
1. Remove the cover and take out the element. Wipe
off the oil and the carbon from inside the case with
a clean rag.
2. Fit in a new oil separator element.
3. Tighten the cover.
(1) Body
(2) Oil separator element
(3) Gasket
(4) Cover
5. Checking positive crankcase
ventilation (PCV) valve
Consult your local KUBOTA Dealer for this service.
6. Checking and cleaning EGR
cooler
Consult your local KUBOTA Dealer for this service.
7. Checking accumulator (front
suspension type)
Consult your local KUBOTA Dealer for this service.
EVERY 2000 HOURS OR 2
YEARS
Be sure to do the following servicing once every 2000
hours or biennially, whichever comes first.
1. Flushing cooling system and
changing coolant
WARNING
To avoid personal injury or death:
• Do not remove the radiator cap while the
coolant is hot. When cool, slowly rotate the cap
to the first stop and allow sufficient time for
excess pressure to escape before removing the
cap completely.
1. Stop the engine and let it cool down.
2. Connect the extension drain hose to the drain plug.
3. To drain the coolant, loosen the drain plug and
remove the radiator cap. The radiator cap must be
removed to completely drain the coolant.
4. After all coolant is drained, tighten the drain plug
securely.
5. Fill with clean soft water and cooling system
cleaner.
6. Follow directions of the cleaner instruction.
7. After flushing, fill with clean soft water and
antifreeze up to the upper line of recovery tank.
8. Install the radiator cap securely.
9. Start and operate the engine for a few minutes.
10. Stop the engine. Check coolant level and add
coolant if necessary.
PERIODIC SERVICE EVERY 1500 HOURS
290
M7132, M7152, M7172