Kubota M7-132, Operator'S Manual

Page: 42 / 332

IMPLEMENT LIMITATIONS
The tractor has been thoroughly tested for proper performance with implements sold or approved by KUBOTA.
Use with implements which are not sold or approved by KUBOTA and which exceed the maximum specifications
listed in the following table, or which are otherwise unfit for use with the tractor may result in malfunctions or failures
of the tractor, damage to other property and injury to the operator or others.
Any malfunctions or failures of the tractor resulting from use with improper implements are not covered by the
warranty.
Tread (max. width)
Lower link end max. lifting capacity: W0
Front Rear
1999 mm 1980 mm 9400 kg
Actual figures
Implement weight and/or size: W1 Max. drawbar load: W2 Trailer loading weight max. capacity: W3
--- As in the following list (See TRAILER LOAD CAPACITY on page 37.)
W0 Lower link end max, hydraulic lifting capacity
W1 Implement weight-the implement’s weight which can be put on the lower link
W2 Max. drawbar load
W3 Trailer loading weight-the max. loading weight for trailer
NOTE :
• Implement size may vary depending on soil operating conditions.
• Strictly follow the instructions outlined in the operator's manual of the mounted or trailed machinery or
trailer, and do not operate the combination tractor-machine or tractor-trailer unless all instructions have
been followed.
• Forestry application
Following hazards exist:
– toppling trees, primarily in case a rear-mounted tree grab-crane is mounted at the rear of the tractor.
– penetrating objects in the operator's enclosure, primarily in case a winch is mounted at the rear of the
tractor.
Optional equipment such as operator protective structure (OPS), falling object protective structure
(FOPS), and so on, to deal with these hazards and other related hazards are not available for this tractor.
Without such optional equipment use is limited to tractor specific applications like transport and
stationary work.
• In case of additional attached devices on the tractor, the machinery directive 2006/42/EC has to be
regarded.
IMPLEMENT LIMITATIONS
36
M7132, M7152, M7172