1.
ATTACH PIANO HINGE TO TRASH
GUARD PLUS®
HARDWARE ASSEMBLY DETAIL
Secure piano hinges to rear of
Trash Guard Plus®
with 3 bolts and 3 nuts as
shown.
.
ATTACHING TRASH GUARD PLUS® TO ROUND BASIN WALL
3.
ATTACH CAP ROUND PANEL TO TRASH GUARD PLUS®
Place two spacers on top of
Trash Guard Plus®
top. Place
Cap Round Cover
over trash guard as shown below. Adjust spacers to align with slots in
Cap
Round Cover
as needed. With washers attached to screws, slide screws
through slots in
Cap Round Cover
and through holes in spacer. Torque
screws to penetrate surface of
Trash Guard Plus®
top.
Drill 2 inch deep
holes into Basin
Wall.
Insert plastic
anchors in
pre-drilled holes
Secure to wall with
6 screws and
washers
2.
ATTACH TRASH GUARD
PLU
S
® TO
BASIN WALL
FIGURE A
Adjust
Cap Round Cover
as needed to fit flush
with curved wall of
Basin Wall
.
When
Cap Round Cover
is flush against wall,
tighten screws to hold in place.
Cap Round
Cover
should be parallel to top of
Trash Guard
Plus®
and flush against
Basin Wall
as shown in
Figure A
below.
Screw
Washer
Spacer
Cap Round Cover
Trash Guard Plu
s
®
Piano
Hinge
