Krone Comprima F 125 XC-1, Operating Instructions Manual

Page: 323 / 374

Terminal error messages 8
Faults of the electrics/electronics 8.1
Comprima F 125 - 1, Comprima F 125 XC - 1, Comprima F 155 - 1, Comprima F 155 XC - 1, Comprima V 150 - 1,
Comprima V 150 XC - 1, Comprima V 180 - 1, Comprima V 180 XC - 1, Comprima V 210 XC - 1
Comfort 1.0_en
79
Possible cause Remedy
FMI 2: The tailgate is open while starting up the machine.
The tailgate is not locked. „
Close the tailgate using the tractor hydraulics.
The sensor is defective or has
been incorrectly set. „ Check and adjust sensors B11 /B12 “Lock hook bale
chamber left/Lock hook bale chamber right”,
refer to
page 52 .
522048-
Tailgate
Possible cause Remedy
FMI 2: – The tailgate is open during road operating mode.
The tailgate is not locked.
„
Close the tailgate using the tractor hydraulics.
The sensor is defective or has
been incorrectly set. „ Check and adjust sensors B11 /B12 “Lock hook bale
chamber left/Lock hook bale chamber right”,
refer to
page 52 .
522049-
Tailgate
Possible cause Remedy
FMI 2: An open tailgate was detected, although no tying has occurred since it was last closed.
The baling pressure is too
high. „
Start net or chamber film wrapping in manual operation and
have the round bale tied,
refer to page 44 .
The bale chamber is overfilled
and it was thus opened by the
round bale. „ Manually empty the bale chamber:
The tailgate is not correctly
locked. „ Open and close the tailgate again.
522101-
B01
Sensor B01 “Speed of bale chamber”
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally. „ Check sensor and wiring for damage, refer to page 64 .
The sensor wiring is faulty.
522102-
B02
Sensor B02 “Tying process active”
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally.
„
Check sensor and wiring for damage, refer to page 64 .
The sensor wiring is faulty.
522105-
B05
Sensor B05 “Slip floor conveyor”