Operation
109
Pos: 43.8 /BA/Bedienung /Rundballenpresse/hohe Ballendichte @ 35\mod_1256125227222_78.docx @ 326331 @ @ 1
If the cutting system is switched on during baling, the bale density will increase
substantially, which makes it necessary to reduce the baling pressure.
Pos: 43.9 /BA/Bedienung /Rundballenpresse/Kurzes Stroh @ 66\mod_1302508002442_78.docx @ 616455 @ @ 1
To do this:
Short, crumbly straw:
• Reduce the number of cutting blades or turn off the cutting system or remove the cutters.
The blades can be stored on the left-hand side of the machine
•
Switch off P.T.O. shaft in headland position
Small, flat swaths:
•
Reduce PTO speed
or
•
Increase travelling speed
Straw varies greatly in structure. Even if no cutting system is used, it is not always possible to
work with the highest possible pressure.
Pos: 43.10 /BA/Bedienung /Rundballenpresse/Hinweis Weichkern einstellen @ 80\mod_1315899545989_78.docx @ 708199 @ @ 1
Note
The inner bale core must only be set to soft with Comprima V150/180(XC) (see section
"Adjusting the Soft Core Setting").
Pos: 43.11 /BA/Bedienung /Rundballenpresse/FahrenFahrgeschwindigkeit @ 35\mod_1256125846472_78.docx @ 326411 @ 2 @ 1
9.2 Travelling
speed
The forward speed during use depends on the following factors:
•
type of crops
•
moisture content of the crops
•
height of swaths
• ground
conditions
Note
The recommended travelling speed is 5 - 12 km/h and must be adapted to local conditions in
actual practice.
• Do not overload the round baler.
•
When baling a round bale, reduce speed at the start and end of the baling process.
Pos: 43.12 /BA/Bedienung /Rundballenpresse/RollbodenEinstellung bei Schlupf des Rollbodens @ 59\mod_1297348303356_78.docx @ 556695 @ @ 1
Setting in case of slip of the floor conveyor if the grass is very wet and only with little
structure
•
Drive with less blades or turn off the blades or remove them and reduce the baling pressure
•
Adjust inner bale core to soft (see Chapter entitled “Adapt Soft Core”)
Pos: 43.13 /BA/Bedienung /Rundballenpresse/Fahrenohne Messer fahren @ 56\mod_1294902558671_78.docx @ 537071 @ @ 1
• Driving without cutters
CAUTION!
Damage to the machine
•
There must be no driving with cutters and switched off cutter base, since the cutters then
have no guidance to the cutting system and the tine can be incised by the cutter.
Pos: 43.14 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
