Settings
167
Pos: 45.22 /Überschriften/Überschriften 2/A-E/B/Bindematerialbremse lösen @ 498\mod_1491370788625_78.docx @ 3423247 @ 2 @ 1
10.2
Releasing the wrapping material brake
Pos: 45.23 /Überschriften/Zwischenüberschriften/A-E/Bei Ausführung Netz- und Garnbindung oder Netzbindung @ 470\mod_1471502729425_78.docx @ 3177359 @ @ 1
For the net and twine tying or net tying version
Pos: 45.24 /BA/Bedienung /Rundballenpresse/Netz-Garnbindung/Netzbremse lösen_Comprima @ 473\mod_1472453682114_78.docx @ 3196331 @ @ 1
b
Note
When the net rocker arm moves down into the feed position, it should be easy to release the
brake to pull off the net.
COM00320_1
1
COM00013_2
4
5
8
6
7
X
Fig. 140
Note
The stronger the tension of the spring (4), the lighter the net is pulled, however it pulls further
towards the middle when starting.
The weaker the tension of the spring (4), the stronger the net is pulled, however it remains
further outwards when starting.
If the settings on the spring (1) are changed, the spring (4) must be adjusted accordingly:
•
Move the net motor into the stored feed position (see chapter Terminal – Menus, "Menu 10
'Manual operation'").
•
Mount the locknut (5) flush with the end of the ring screw (6).
•
Mount the wire rope (7) with the wire rope clamps (8), without pressing the springs (4)
together.
•
Tighten the locknut (5) until the spring (4) is set to the dimension
X=130 mm
.
Note
To set the dimension
Y
, see chapter Operation Device "Checking the retaining comb during
net tying".
Pos: 45.25 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
