Krone Comprima F 125 XC-1, Operating Instructions Manual

Page: 320 / 374

8 Terminal error messages
8.1 Faults of the electrics/electronics
76
Comprima F 125 - 1, Comprima F 125 XC - 1, Comprima F 155 - 1, Comprima F 155 XC - 1, Comprima V 150 - 1,
Comprima V 150 XC - 1, Comprima V 180 - 1, Comprima V 180 XC - 1, Comprima V 210 XC - 1
Comfort 1.0_en
Possible cause Remedy
FMI 7: The net stops during activated tying. The net tears off after the starting process or dur-
ing tying.
The roll brake has been set
with too much force.
„
Check the setting of the roll brake.
The cutting unit has lowered
into the net. „
Remove contamination from the cutting unit.
„
Check the setting of the cutting unit.
„ Check whether the cutting unit is engaged/clamped during
the feed process.
The cutting unit has not en-
gaged.
The cutting unit has been set
too deep.
522021-
Chamber film wrapping
Possible cause Remedy
FMI 7: The film stops during activated tying. The film tears off after the starting process or dur-
ing tying.
The brake discs have not
been set correctly. „ Reduce the braking effect of the brake discs, see chapter
Maintenance, “Checking and setting the braking effect of the
brake discs”.
The cutting unit has lowered
into the film. „
Remove contamination from the cutting unit.
„
Check the setting of the cutting unit.
„ Check whether the cutting unit is engaged/clamped during
the feed process.
The cutting unit has not en-
gaged.
The cutting unit has been set
too deep.
The rotational speed is too
high.
„
Check the rotational speed. It must not be higher than 540
rpm.
522022-
Net wrapping
Possible cause Remedy
FMI 7: The net is running even though tying has not been started.
The net is pulled during bal-
ing.
„
Intensify the tension of the spring for the wrapping material
brake, see chapter Settings, “Setting the wrapping material
brake”.
The net is too far in the bale
channel.
„
Check the net overhang.
„ Check sensor B61 “Tying 1 (passive)” and set the feed
position,
refer to page 57 .
522022-
Chamber film wrapping
Possible cause Remedy
FMI 7: The film is running even though tying has not been started.
The film overhang is too long.
„
Check the film overhang. Make sure it is max. 250 mm.
„
Check and set the braking effect of the brake discs, see
chapter Maintenance, “Checking and setting the braking
effect of the brake discs”.