Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 272/1246
no -
This command removes an association between a multiple spanning tree instance and a VLAN.
The VLAN will again be associated with the common and internal spanning tree. The instance
<0-4094> is a number that corresponds to the desired existing multiple spanning tree instance. The
<1-4093> corresponds to an existing VLAN ID.
Default Setting
None
Command Mode
Global Config
This command sets the Path Cost or Port Priority for this port within the multiple spanning tree instance
or in the common and internal spanning tree. If the <1-4094> parameter corresponds to an existing
multiple spanning tree instance, then the configurations are done for that multiple spanning tree
instance. If however 0 (defined as the default CIST ID) is passed as the <1-4094>, then the
configurations are performed for the common and internal spanning tree instance.
If the
‘cost’ token is specified, this command sets the path cost for this port within a multiple spanning
tree instance or the common and internal spanning tree instance, depending on the <1-4094>
parameter. The pathcost can be specified as a number in the range of 1 to 200000000 or auto. If "auto"
is specified, the pathcost value will be set based on Link Speed.
Syntax
spanning-tree mst <1-4094> cost {<1-200000000> | auto}
no spanning-tree mst <1-4094> cost
<1-4094> -
multiple spanning tree instance ID.
no -
This command sets the Path Cost or Port Priority for this port within the multiple spanning tree
instance or in the common and internal spanning tree to the respective default values. If the
<1-4094> parameter corresponds to an existing multiple spanning tree instance, then the
configurations are done for that multiple spanning tree instance. If however, 0 (defined as the default
CIST ID) is passed as the <1-4094>, then the configurations are performed for the common and
internal spanning tree instance.
If the
‘cost’ token is specified, this command sets the path cost for this port within a multiple spanning
tree instance or the common and internal spanning tree instance, depending on the <1-4094>
parameter, to the default value, that is, a pathcost value based on the Link Speed.
Default Setting
Cost : auto
Command Mode
Interface Config
