Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 186/1246
6.3.2
Serial Interface Commands
6.3.2.1
show line console
This command displays serial communication settings for the switch.
Syntax
show line console
Default Setting
None
Command Mode
Privileged Exec
Display Message
Serial Port Login Timeout (minutes):
Specifies the time, in minutes, of inactivity on a Serial port
connection, after which the Switch will close the connection. Any numeric value between 0 and 160
is allowed, the factory default is 5. A value of 0 disables the timeout.
Baud Rate:
The default baud rate at which the serial port will try to connect. The available values are
1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200 bauds.
Character Size:
The number of bits in a character. The number of bits is always 8.
Flow Control:
Whether Hardware Flow-Control is enabled or disabled. Hardware Flow Control is
always disabled.
Stop Bits:
The number of Stop bits per character. The number of Stop bits is always 1.
Parity:
The Parity Method used on the Serial Port. The Parity Method is always None.
Password Threshold:
When the logon attempt threshold is reached on the console port, the system
interface becomes silent for a specified amount of time before allowing the next logon attempt. (Use
the silent time command to set this interval.) When this threshold is reached for Telnet, the Telnet
logon interface closes.
Silent Time (sec):
Use this command to set the amount of time the management console is
inaccessible after the number of unsuccessful logon attempts exceeds the threshold set by the
password threshold command.
Terminal Length:
The columns per page for terminal serial port.
