Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 422/1246
6.10.2.2
sntp client mode
This command will enable Simple Network Time Protocol (SNTP) client mode and optionally setting the
mode to either broadcast, multicast, or unicast.
Syntax
sntp client mode [broadcast | unicast | multicast]
no sntp client mode
no -
This command will disable Simple Network Time Protocol (SNTP) client mode.
i
The SNTP IPv4 multicast address is 224.0.1.1.
The SNTP IPv6 multicast address is ff05::101.
IPv6 address doesn
’t support broadcast mode.
Default Setting
None
Command Mode
Global Config
6.10.2.3
sntp client port
This command will set the SNTP client port id and polling interval in seconds.
Syntax
sntp client port <portid>
no sntp client port
<portid> -
SNTP client port id.
no -
Resets the SNTP client port id.
Default Setting
The default portid is 123.
Command Mode
Global Config
