Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 1131/1246
Specific Static Entry
- Selecting this allows the user to specify the required IP Address.
Specific Interface
- Selecting this allows the user to specify the required interface.
None
- Selected if the user does not want to delete any entry from the ARP Table.
Remove IP Address
- This appears only if the user selects Specific Dynamic/Gateway Entry or
Specific Static Entry in the Remove from Table Drop Down List. Allows the user to enter the IP
Address against the entry that is to be removed from the ARP Table.
Slot/Port
- The routing interface associated with the ARP entry.
Non-Configurable Data
Total Entry Count
- Total number of Entries in the ARP table.
Peak Total Entries
- Highest value reached by Total Entry Count. This counter value is restarted
whenever the ARP table Cache Size value is changed.
Active Static Entries
- Total number of Active Static Entries in the ARP table.
Configured Static Entries
- Total number of Configured Static Entries in the ARP table.
Maximum Static Entries
- Maximum number of Static Entries that can be defined.
IP Address
- The IP address of a device on a subnet attached to one of the switch's routing
interfaces.
MAC Address
- The unicast MAC address for the device. The format is six two-digit hexadecimal
numbers separated by colons, for example 00:06:29:32:81:40.
Slot/Port
- The routing interface associated with the ARP entry.
Type
- The type of the ARP entry:
Local
- An ARP entry associated with one of the switch's routing interface's MAC addresses
Gateway
- A dynamic ARP entry whose IP address is that of a router
Static
- An ARP entry configured by the user
Dynamic
- An ARP entry which has been learned by the router
Age
- Age since the entry was last refreshed in the ARP Table. The format is hh:mm:ss.
Command Buttons
Submit
- Update the switch with the values on this screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.
