Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 1036/1246
9.4.3
Managing Captive Portal
9.4.3.1
Configuring Captive Portal Global Configuration Page
Configurable Data
Enable Captive Portal
- Select the check box to enable the CP feature on the switch. Clear the
check box to disable the captive portal feature.
Additional HTTP Port
- HTTP traffic uses port 80, but you can configure an additional port for HTTP
traffic. Enter a port number between 0-65535 (excluding ports 80, 443, and the configured switch
management port).
Additional HTTP Secure Port
- HTTP traffic over SSL (HTTPS) uses port 443, but you can
configure an additional port for HTTPS traffic. Enter a port number between 0-65535 (excluding ports
80, 443, and the configured switch management port).
Authentication Timeout
- To access the network through a portal, the client must first enter
authentication information on an authentication W eb page. Enter the number of seconds to keep the
authentication session open with the client. W hen the timeout expires, the switch disconnects any
active TCP or SSL connection with the client.
Non-Configurable Data
CP Global Operational Status
- Shows whether the CP feature is enabled.
CP Global Disable Reason
- If CP is disabled, this field displays the reason, which can be one of
the following:
‧
None
‧
Administratively Disabled
‧
No IPv4 Address
‧
Routing Enabled, but no IPv4 routing interface
Command Buttons
Submit
- Sends the updated screen to the switch and causes the changes to take effect on the
switch but these changes will not be retained across a power cycle unless a save is performed.
Refresh
- Update the information on the page.
