Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 248/1246
6.3.15
Service Port Commands
6.3.15.1
show serviceport
This command displays service port configuration information.
Syntax
show serviceport
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface Status:
Indicates whether the interface is up or down.
IP Address:
The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask:
The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway:
The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6 Administrative Mode:
Whether enabled or disabled. Default value is enabled.
IPv6 Prefix is:
The IPv6 address and length. Default is Link Local format.
IPv6 Default Router:
The default gateway address on the service port. The factory default value is
an unspecified address.
Configured IPv4 Protocol:
Indicate what IPv4 network protocol was used
on the last, or current power-up cycle, if any.
Configured IPv6 Protocol:
Indicate what IPv6 network protocol was used on the last, or current
power-up cycle, if any.
IPv6 AutoConfig Mode:
Whether enabled or disabled. Default value is disabled.
IPv6 Link-local Scope ID:
The scope ID for this interface
Burned In MAC Address:
The burned in MAC address used for in-band connectivity.
