Korenix Technology Co., Ltd.
Industrial
Layer 3 Managed Ethernet Switch
_____________________________________________________________________________
Industrial Layer 3 Managed Ethernet SwitchUser Manual
Page: 604/1246
6.25.2.2
iscsi cos
This command sets the quality of service profile that will be applied to iSCSI flows. iSCSI flows are
assigned by default to the highest VPT/DSCP mapped to the highest queue not used for stack
management. The user should also take care of configuring the relevant Class of Service parameters for
the queue in order to complete the setting.
Setting the VPT/DSCP sets the QoS profile which determines the egress queue to which the frame is
mapped. The switch default setting for egress queues scheduling is Weighted Round Robin (WRR).
You may complete the QoS setting by configuring the relevant ports to work in other scheduling and
queue management modes via the Class of Service settings. Depending on the platform, these choices
may include strict priority for the queue used for iSCSI traffic. The downside of strict priority is that, in
certain circumstances (under heavy high priority traffic), other lower priority traffic may get starved. In
WRR the queue to which the flow is assigned to can be set to get the required percentage.
Syntax
iscsi cos { dscp <dscp> [remark] | vpt <vpt> }
no iscsi cos
vpt/dscp -
The VLAN Priority Tag or DSCP to assign iSCSI session packets.
remark -
Mark the iSCSI frames with the configured VPT/DSCP when egressing the switch.
no -
Use this command to disable VoIP Profile on the interface.
Default Setting
5 (vpt)
Command Mode
Global Config.
