SERVICE MANUAL
4–16
10FEB97 – SM3226-1
Setting Film Density - Beam Splitter Pulse Settings
Important
If you do this procedure, you must do the procedure “Calibrating the Printer” on Page 4–4.
Use this procedure to set density values other than those set at the factory.
[1] Install the PORTABLE COMPUTER. See “Using the Portable Computer” in the Diagnostic Section.
[2] Load customer film into the SUPPLY MAGAZINE.
[3] Energize the LASER PRINTER.
[4] Use the PORTABLE COMPUTER to display the
CES Main Menu.
[5] Enter [1] for “Monitor Mode”.
[6] Enter [8] to set Beam-splitter.
[7] Enter [1] to print gray scale.
[8] Enter the correct number corresponding to the size
of the film loaded into the SUPPLY MAGAZINE.
• 0: 8x10
• 1: 11x14
• 2: 35x35
• 3: 35x43
[9] Press [0] for RECEIVE MAGAZINE or [1] for
processor.
[10] Press [ENTER] for default at the “Initial pulse?”
prompt.
[11] If using 35 x 43 cm film, press [ENTER] for
default at the “Each pulse?” prompt.
[12] If using other than 35 x 43 cm film, press [2] [0]
at the “Each pulse?” prompt.
MAIN MENU
1 Monitor Mode 4 System Params
2 System Logs 5 Debug Utility
3 Boards Diag
Enter Menu Item:
MONITOR MODE MENU
1 Motors 5 Sensors
2 Solenoids 6 Board Diag
3 Relay 7 Enter Commands
4 Miscellaneous 8 Set Beam-Splitter
Enter Menu Item:
SET BEAM-SPLITTER MENU
1 Print Grey Scale 4 Show Pulse
2 Enter Density 5 Set Each Pulse
3 Set Normal Status
Enter Manu Item:
Caution! Laser will be turned on.
Film size? (0-3) [3]:
Film size? (0-3) [3]: x
R-Magazine or Processor? (0/1) [0] :
Initial pulse? (0 to 200) [50] :
Initial pulse? (0 to 200 [50] :
Each pulse? (0 to 200) [10] :
How many times? (1 to 10) [10] :
