Operation Adjustments
SM3226-1 – 10FEB97
4–9
Using the Kodak Process Control DENSITOMETER as a Stand-alone DENSITOMETER
The Kodak PROCESS CONTROL DENSITOMETER
can also be used to read the 9 density values. To do so,
use the following procedure:
[1] Prepare the DENSITOMETER for use.
[2] After passing the self-test, the DENSITOMETER
will display:
[3] Simultaneously press [MENU] and [MENU].
[4] Position the film tightly up to the Stop of the
DENSITOMETER, then insert the film until it
rests against the drive rollers and the motor is
activated.
Note
Always read the densities with the emulsion side of the
film facing up. The notch should be in the upper right
hand corner.
[5] While the film is measured, hold the film against
the Stop, guiding the film to prevent skewing.
[6] Press the right-side [MENU] key that is under the
displayed word “go”.
[7] Press the right-side [MENU] key again when the
DENSITOMETER displays “go”.
CH:I (lab identifier) CH:I go
