SERVICE MANUAL
3–12
10FEB97 – SM3226-1
(b) If the pressure is not correct, check the frequency of the ELECTRONIC PUMP. See the procedure on
Page 5–6.
Note
The following steps are provided to complete the film transport cycle.
[16] Enter [F] [D] [B] to move the film to the SUPPLY
ROLLER.
[17] Enter [T] [R] [S] to transport the film to the
RECEIVE ROLLER.
[18] Enter the correct number corresponding to the size
of the film loaded in the SUPPLY MAGAZINE.
• 0: 8x10
• 1: 11x14
• 2: 35x35
• 3: 35x43
[19] Enter [0] to continue.
[20] Press [Enter] for defaults.
[21] Enter [P] [O] [N] to energize the POLYGON
MOTOR.
[22] Enter [P] [R] [I] to print an image.
[23] Enter [0] for yes.
[24] Enter the correct number corresponding to the size
of the film loaded in the SUPPLY MAGAZINE.
• 0: 8x10
• 1: 11x14
• 2: 35x35
• 3: 35x43
[25] Press [Enter] for defaults.
Enter command:FDB
Enter command:TRS
Film size? (0-3):
Film size? (0-3):X
Continue or step? (0 or 1):
Continue or step? (0 or 1): 0
Default parameters or set again? (0 or 1):
Default parameters or set again? (0 or
1):0
error=0
Enter command:PON
Enter command:PRI
Caution! Laser will be turned on.
Polygon ready, yes or no? (0 or 1):
Polygon ready, yes or no? (0 or 1): 0
Film size? (0-3):
Film size? (0-3):X
Default parameters or set again? (0 or 1):
Default parameters or set again? (0 or
1):0
error=0