Kikusui KHA3000, Operation Manual, Page: 291 / 392

13
KHA3000
291
Rem
ote Control
Measurements in General
Operation mode
The messages shown below ("Setting the Operation Mode" on page 292 to "Scaling" on page
297) are valid in any operation mode (harmonic measurement, voltage fluctuation
measurement, basic measurement, FFT analyzer or in-rush current measurement). Other
messages are explained separately according to the operation mode. Each of these
messages is valid in the relevant operation mode.
Measurement circuit wiring methods and input circuit setting
(linked or independent)
The methods of wiring measurement circuits include single-phase two-wire (1P2W), single-
phase three-wire (1P3W), three-phase three-wire (3P3W) and three-phase four-wire (3P4W).
For input circuit setting of each input phase (turning on/off of voltage and current ranges and
voltage and current AUTO ranges), select ON (linked) or OFF (independent).
The messages used for this setting and their functions ( : valid, : invalid) are shown below:
●
When the input circuit setting is “ linked ” (INP: LINK ON)
●
When the input circuit setting is “ independent ” (INP: LINK OFF)
Command INPut:WIRing:METHod
1P2W 1P3W 3P3W 3P4W
CURR:RANG
CURR:RANG:AUTO
VOLT:RANG
VOLT:RANG:AUTO
CURR:RANG:IND
CURR:RANG:AUTO:IND
VOLT:RANG:IND
VOLT:RANG:AUTO:IND
Command INPut:WIRing:METHod
1P2W 1P3W 3P3W 3P4W
CURR:RANG
CURR:RANG:AUTO
VOLT:RANG
VOLT:RANG:AUTO
CURR:RANG:IND
CURR:RANG:AUTO:IND
VOLT:RANG:IND
VOLT:RANG:AUTO:IND