Kikusui KHA3000, Operation Manual, Page: 319 / 392

13
KHA3000
319
Rem
ote Control
Test Execution (Trigger Function)
The test is executed by the following three functions:
• Sequence 1 (ACQuire): Voltage, current and harmonic current measurement
• Sequence 2 (RUSH): In-rush current measurement
• Sequence 3 (TEST): Execution of the harmonic or voltage fluctuation test
Sequence 1 (ACQuire)
INIT
INIT:NAME
Starts the trigger function. The command is invalid during the analysis state.
After the INIT command is sent, measurement begins immediately when TRIG:SOUR:IMM is
specified. When TRIG:SOUR:BUS is specified, measurement begins upon a software trigger.
The INIT command abandons and nullifies the measurement data collected previously. If an
FETC? query is sent immediately after the INIT command is sent, measurement data is
returned after completion of measurement.
Command (Sequence 1)
Command
INITiate[:IMMediate][:SEQuence[1]]
INITiate[:IMMediate]:NAME {ACQuire}
Parameter Value: ACQuire
INIT:CONT
INIT:CONT:NAME
Sets the automatic continuation mode (ON/OFF) of sequence operation. The command is
invalid during the analysis state.
●
When the automatic continuation mode is ON
When TRIG:SOUR:IMM is specified, measurement begins immediately. After the
measurement is finished, new measurement begins automatically.
When TRIG:SOUR:BUS is specified, measurement begins upon a software trigger. After
the measurement is finished, the system waits for another trigger.
●
When the automatic continuation mode is OFF
The measurement currently in progress is continued unless ABOR is sent. New
measurement is not automatically continued.
Command
INITiate:CONTinuous[:SEQuence[1]] {ON|OFF|1|0}
INITiate:CONTinuous[:SEQuence[1]]?
INITiate:CONTinuous:NAME {ACQuire},{ON|OFF|1|0}
INITiate:CONTinuous:NAME?{ACQuire}
Parameter Value: ON(1) Automatic continuation mode ON
OFF(0) Automatic continuation mode OFF (default)
Response
Returns the automatic continuation mode (ON/OFF) of sequence operation in the <NR1>
format.
** RST RST