Kikusui KHA3000, Operation Manual, Page: 346 / 392

346
KHA3000
Default Conditions
p. 376
When *RST or MEAS? is sent or the power is turned on, parameters are set as shown in
table below.
See
Command
Parameter value
Unit Function
*RST
MEAS?
*1
Power-on
INP:LINK 1(ON)
Same –
Setting
immediately
before the
POWER
switch is
turned off
– Sets the input circuit of each
input phase (channel) to the
same value or sets it
independently.
INP:WIR:METH “ 3P4 W” – – Wiring method
INP:PLL:SOUR VL1 – – PLL input phase
INP:COUP DC DC A Input coupling
INP:FILT:FREQ 6000 6000 Hz Cutoff frequency of anti-
aliasing filter
INP:CURR:TERM SHUNt
(all
channels) – – Current input terminal (phases
linked)
INP:CURR:TERM:IND SHUNt – – Current input terminal (phases
independent)
FUNC “HARM” – – Operation mode
CURR:RANG
CURR:RANG:IND Selected
value for the
auto range Selected
value for the
auto range A Current range (phases linked
or independent)
CURR:RANG:AUTO
CURR:RANG:AUTO:IND 1(ON) 1(ON) – Enable or disable Auto Range
of current range
VOLT:RANG
VOLT:RANG:IND Selected
value for the
auto range Selected
value for the
auto range V Voltage range (phases linked,
phases independent)
VOLT:RANG:AUTO
VOLT:RANG:AUTO:IND 1(ON) 1(ON) – Enables/Disables the auto
range for the voltage range
CURR:SCAL 0(OFF) – – Enable/disable current scaling
CURR:SCAL:CF 4.00 – – Current CF
CURR:SCAL:CTR 1.000 – – CT Ratio
CURR:SCAL:ESCR 25.000 – – EXT-CS
CURR:SCAL:PADJ 0.00 – – Phase adjustment value for
the external current sensor
VOLT:SCAL 0(OFF) – – Enable/disable voltage scaling
VOLT:SCAL:CF 2.00 – – Voltage CF
VOLT:SCAL:PTR 1.000 – – PT Ratio
HARM:STAN:LIM:NAME “IEC 61000-
3-2Ed5.0 ”
No change – Harmonic current limit value
standard
HARM:STAN:MTEC:NAME “IEC 61000-
4-7Ed2.0A1 ”
No change – Harmonic current measuring
technique standard
HARM:STAN:LIM:ALI 0(OFF) – – Specifies the naming of
Standard
HARM:STAN:LIM:ALI:NAME Standard
name – – Limitation standard name
HARM:STAN:MTEC:ALI:NAME Standard
name
– – Measuring technique name
HARM:NOM:FREQ 50 – Hz Nominal frequency
HARM:NOM:VOLT 230 – V Nominal voltage
HARM:MARG 100 – % Margin
HARM:MTIM 150 – s Measurement time