Kikusui KHA3000, Operation Manual, Page: 374 / 392

Error List
374
KHA3000
Execution error list
An error in the [-299, -200] range indicates that an error was detected by the execution control
block of the measuring instrument. If an error in this class occurs, the execution error bit (bit
4) of the event status register is set.
Specific device error list
Error code Explanation of error message
-200 Execution error (generic) A generic error for this product
-203 Command protected Password protected program or query command cannot be executed.
-210 Trigger error A trigger error
-211 Trigger ignored A trigger was received but discarded.
-213 Init ignored Measurement initiate operation was ignored because measurement is in
progress.
-214 Trigger deadlock Dead lock occurred because a query was received before the software trigger.
-220 Parameter error A program data element related error occurred.
-221 Settings conflict Received a command that cannot be executed in the current condition of this
product.
-222 Data out of range Parameter value was outside the legal range.
-223 Too much data Too many parameters were received than the requirements.
-224 Illegal parameter value Received an invalid parameter data.
-230 Data corrupt or stale Received a data query before the measurement was completed.
-241 Hardware missing Cannot be executed because the optional hardware is not installed.
Error code Explanation of error message
-330 Self-test failed Self-diagnosis failure
-360 Communication error Communication failure
-361 Parity error in program
message Invalid parity bit
-362 Framing error in program
message Framing error. A stop bit cannot be detected.
-363 Input buffer overrun The input buffer is full.
-365 Time out error Timeout