Kikusui KHA3000, Operation Manual, Page: 293 / 392

13
KHA3000
293
Measurements in General
Rem
ote Contr
ol
Parameter Value: SHUNt Internal shunt (default)
CLAMp Clamp type current sensor
BNC External signal input
Response
Returns the current input terminal setting in the <character> format.
INP:CURR:TERM:IND
Sets the current input terminals. Each input phase (channel) is set independently.
This command is enabled when the input circuit setting is
“ independent ” (INP:LINK OFF).
Command
INPut:CURRent:TERMinal:IHDependent
<character>,<character>,<character>
INPut:CURRent:TERMinal:INDependent?
Parameter Value: SHUNt Internal shunt (default)
CLAMp Clamp type current sensor
BNC External signal input
Specify the <character> commands in the order of <L1 phase>, <L2 phase> and
<L3 phase>.
Response
Returns the current ranges in the <character>, <character>, <character> format. The
<character> responses are in the order of <L1 phase>, <L2 phase> and <L3 phase>.
Setting the PLL Source to Synchronize with the AC Power
Supply
INP:PLL:SOUR
Sets the PLL source to synchronize with the frequency of the AC power supply.
Voltage or current signal in each of the L1, L2 and L3 phases can be selected. Select EXT
when using the input signals of EXT SYNC INPUT.
Command
INPut:PLL:SOURce {CL1|CL2|CL3|VL1|VL2|VL3|EXT}
INPut:PLL:SOURce?
Parameter Value: CL1, CL2, CL3 Current signals in L1, L2 and L3 phases
VL1, VL2, VL3 Voltage signals in L1(default), L2 and L3 phases
EXT Input signal in EXT SYNC INPUT
Response
Returns the PLL source in the <character> format.
** RST RST
** RST RST