Kikusui KHA3000, Operation Manual, Page: 296 / 392

296
KHA3000
Measurements in General
VOLT:RANG:IND
Sets the voltage range of each input phase (channel) independently.
Command
[SENSe:]VOLTage:RANGe:INDependent
<numeric>,<numeric>,<numeric>
[SENSe:]VOLTage:RANGe:INDependent?
Parameter Value: 150, 300, 600 (The default is the value selected for the auto range.)
Specify the <numeric> commands in the order of <L1 phase>, <L2 phase> and
<L3 phase>.
Unit: V
Response
Returns the voltage range values in the <NR3>, <NR3>, <NR3> format. The <NR3>
responses are in the order of <L1 phase>, <L2 phase> and <L3 phase>.
CURR:RANG:AUTO
VOLT :RANG:AUTO
Decides whether to enable the auto range for the current or voltage ranges of all input phases
(channel). When either CURR:RANGE:AUTO or VOLT:RANGE:AUTO is set, the other
parameter is set to the same value.
Command
[SENSe:]CURRent:RANGe:AUTO {ON|OFF|1|0}
[SENSe:]CURRent:RANGe:AUTO?
[SENSe:]VOLTage:RANGe:AUTO {ON|OFF|1|0}
[SENSe:]VOLTage:RANGe:AUTO?
Parameter Value: ON(1) Enables the auto range.
OFF(0) Disables the auto rang (default).
Response
Returns whether the auto range is enabled or disabled in the <NR1> format.
CURR:RANG:AUTO:IND
VOLT :RANG:AUTO:IND
Decides whether to enable the auto range for the current or voltage range of each input
phase
(channel) independently. When either CURR:RANG:AUTO:IND or
VOLT:RANG:AUTO:IND is set, the other parameter is set to the same value.
Command
[SENSe:]CURRent:RANGe:AUTO:INDependent <bool>,<bool>,<bool>
[SENSe:]CURRent:RANGe:AUTO?
[SENSe:]VOLTage:RANGe:AUTO:INDependent <bool>,<bool>,<bool>
[SENSe:]VOLTage:RANGe:AUTO?
Parameter Value: ON(1) Enables the auto range.
OFF(0) Disables the auto rang (default).
Specify the <bool> commands in the order of <L1 phase>, <L2 phase> and <L3
phase>.
Response
Returns whether the auto range is enabled or disabled in the <NR1>, <NR1>, <NR1>
format. The <NR1> responses are in the order of <L1 phase>, <L2 phase> and <L3 phase>.
** RST RST
** RST RST
** RST RST