Kikusui KHA3000, Operation Manual, Page: 361 / 392

15
KHA3000
361
Specifications
Specifications
External Equipment Control Function
General Specifications
Item Specifications
AC power supply
control Setup item Voltage, frequency, range, ON phase, OUTPUT on/off
RS232C
communication
speed 9600 bps
Item Specifications
AC input Nominal input rating 100 V to 240 V, 50 Hz to 60 Hz
Voltage range 90 V to 250 V
Maximum power
consumption 250 VA
Withstanding
voltage AC input

chassis No abnormality should occur at 1500 Vac for one minute.
Test terminal

chassis
No abnormality should occur at 3550 Vac for one minute.
Test terminal

Test terminal
Insulation
resistance AC input

chassis
500 Vdc, 100 M

or higher
Test terminal

chassis
Earth continuity Power code
connector, grounding
pin

chassis
25 Aac/0.1

or less
Environment Installation location Indoor, up to 2000 m, overvoltage category II
Temperature
and humidity
ranges
Operating
temperature 0
°C
to +40
°C
(+32
°F to +104 °F
)
Operating humidity 20 %rh to 80 %rh (no condensation)
Storage temperature -20
°C
to +70
°C (-4 °F to +158 °F)
Storage humidity 90 %rh or less (no condensation)
Safety Conforming to the following standard requirements:
IEC 61010-1:2001
(Class I
*1
, Pollution degree 2
*2
)
*1. This is a Class I equipment. Be sure to ground this product’s protective conductor terminal. The
safety of this product is only guaranteed when the product is properly grounded.
*2. Pollution is addition of foreign matter (solid, liquid or gaseous) that may produce a reduction of
dielectric strength or surface resistivity. Pollution Degree 2 assumes that only non-conductive
pollution will occur except for an occasional temporary conductivity caused by condensation.
Outside dimensions Refer to “ Outside Dimensions ”
Weight Approx. 10 kg (22.05 lb)
Accessories Power cord 1
Voltage sensing
terminal plug 3 (product shipped with this plug installed)
Voltage sensing
terminal short-circuit
wire kit 3 (two wires: product shipped with these wires attached to the
voltage sensing terminal)
Voltage sensing terminal
plug screwdriver 1
Spare fuse 1 (250 V, 2.5 A(T), in the power supply fuse holder)
Operation manual 1 (this manual)