JDS Uniphase CellAdvisor JD780A Series, User Manual

Page: 68 / 592

JD780A Series Analyzers
68
Using Spectrum Analyzer
Display the input signal’s maximum response only
(unlimited or for a certain amount of time)
Max Hold M
Display the input signal’s minimum
response only
(unlimited or for a certain amount of time)
Min Hold m
Capture the selected trace and compare traces Capture C
Load a saved trace More (1/2) > Load L
Hide the selected trace Trace View > Off F
Remove all the traces and initialize the trace
settings More (1/2) > Trace
Clear All
NOTE
For the Max Hold and Min Hold , your instrument compares newly acquired data with the
active trace and displays larger maximum values or smaller minimum values on the
screen. You can set it to
Unlimited to hold and view maximum or minimum data or
specify a certain amount of time up to 60 seconds by using numeric keys or the rotary
knob.
4.
To select the detection option, press the More (1/2) > Detectors , and then do one of the
following:
To display Select
Random noise better than the peak without missing signals Normal
The highest value in each data point Peak
The root mean squared average power across the spectrum RMS
The lowest value in each data point Negative Peak
The center value in each data point Sample
5.
Optional . Press the More (1/2) > Trace Info soft key, and then select the trace number to view
the trace
’s parameter setting information stored at the time of the measurement or
None to hide
the information display.
6.
Optional. If you have the two traces T1 and T2, you can perform trace math. To view the power
difference between the traces, press the T1
– T2 -> T5
or T2
– T1 -> T6
soft key.
The result is overlaid on the screen along with the second Y-axis.
NOTE
To be able to load a trace, the trace to be overlaid must be saved in the same
measurement mode and frequency setting as the current measurement.
Setting limit
Procedure
To use the display line:
1.
Press the LIMIT hot key.
2.
Press the Display Line soft key for a reference line.
3.
Enter a value, and then press the dBm unit soft key.
4.
Toggle the Display Line soft key between On and Off to display and dismiss the reference line.
The straight line appears across the screen to be used as a visual reference only.