Intel 480T, User Manual

Page: 62 / 367

60
C H A P T E R 3 Accessing the Switch
IP Host Configuration Commands
Table 12 describes the commands that are used to configure IP
settings on the switch.
Table 12: IP Host Configuration Commands
Command Description
clear iparp {<ipaddress> | vlan <name>} Removes dynamic entries in the IP ARP
table. Permanent IP ARP entries are not
affected.
config iparp add <ipaddress> <mac_address> Adds a permanent entry to the Address
Resolution Protocol (ARP) table. Specify
the IP address and MAC address of the
entry.
config iparp delete <ipaddress> Deletes an entry from the ARP table.
Specify the IP address of the entry.
config iproute add <ipaddress> <mask>
<gateway> {<metric>} {unicast-only | multicast-
only} Adds a static address to the routing table.
Use a value of 255.255.255.255 for
mask
to indicate a host entry.
config iproute add default <gateway> {<metric>}
{unicast-only | multicast-only} Adds a default gateway to the routing
table. A default gateway must be located
on a configured IP interface. If no metric
is specified, the default metric of 1 is
used. Use the unicast-only or multicast-
only options to specify a particular traffic
type. If not specified, both unicast and
multicast traffic uses the default route.
config iproute delete <ipaddress> <mask>
<gateway> Deletes a static address from the routing
table.
config iproute delete default <gateway> Deletes a default gateway from the
routing table.
show iparp {<ipaddress | vlan <name> |
permanent} Displays the IP ARP table. You can filter
the display by IP address, VLAN, or
permanent entries.