Intel 480T, User Manual

Page: 190 / 367

188
C H A P T E R 1 0 IP Unicast Routing
Table 47 describes the commands used to configure IP options and
the ICMP protocol.
enable iproute sharing Enables load sharing if multiple routes to the
same destination are available. Only paths
with the same lowest cost are shared. The
default setting is disabled.
rtlookup [<ipaddress> | <hostname>] Performs a look-up in the route table to
determine the best route to reach an IP
address.
Table 46: Route Table Configuration Commands (continued)
Command Description
Table 47: ICMP Configuration Commands
Command Description
config irdp <mininterval> <maxinterval>
<lifetime> <preference> Configures the router advertisement message
timers, using seconds. Specify:
•
mininterval
— The minimum amount
of time between router advertisements.
The default setting is 450 seconds.
•
maxinterval
— The maximum time
between router advertisements. The
default setting is 600 seconds.
•
lifetime
— The default setting is 1,800
seconds.
•
preference
— The preference level of
the router. An ICMP Router Discover
Protocol (IRDP) client always uses the
router with the highest preference level.
Change this setting to encourage or
discourage the use of this router. The
default setting is 0.