Intel 480T, User Manual

Page: 211 / 367

C H A P T E R 1 1 RIP and OSPF
209
config rip rxmode [none | v1only | v2only |
any] {vlan <name>} Changes the RIP receive mode for one or all
VLANs. Specify:
•
none
— Drop all received RIP packets.
•
v1only
— Accept only RIP v1 format
packets.
•
v2only
— Accept only RIP v2 format
packets.
•
any
— Accept both RIP v1 and v2
packets.
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is
any
.
config rip txmode [none | v1only | v1comp |
v2only] {vlan <name>} Changes the RIP transmission mode for one
or all VLANs. Specify:
•
none
— Do not transmit any packets on
this interface.
•
v1only
— Transmit RIP v1 format
packets to the broadcast address.
•
v1comp
— Transmit RIP v2 format
packets to the broadcast address.
•
v2only
— Transmit RIP v2 format
packets to the RIP multicast address.
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is
v2only
.
config rip updatetime {<delay>} Changes the periodic RIP update timer. The
timer granularity is 10 seconds. The default
setting is 30 seconds.
config rip vlan [<name> | all] cost <number> Configures the cost (metric) of the interface.
The default setting is 1.
enable rip Enables RIP. The default setting is disabled.
Table 51: RIP Configuration Commands (continued)
Command Description