Intel 480T, User Manual

Page: 53 / 367

C H A P T E R 3 Accessing the Switch
51
Access Profile Rules
The following rules apply when using access profiles:
• Only one access profile can be applied to each application.
• The access profile can either permit or deny the entries in the
profile.
• The same access profile can be applied to more than one
application.
Access Profile Example
The following example creates an access profile named testpro , and
denies access for the device with the IP address 192.168.10.10:
create access-profile testpro type ipaddress
config access-profile testpro mode deny
config access-profile testpro add ipaddress
192.168.10.10/32
The following command applies the access profile testpro to Telnet:
enable telnet access-profile testpro
To view the contents of an access profile, use the following
command:
show access-profile <access_profile>
To view the Telnet configuration, use the following command:
show management
Using Telnet
Any workstation with a Telnet facility should be able to
communicate with the switch over a TCP/IP network.
Up to eight active Telnet sessions can access the switch
concurrently. If
idletimeouts
are enabled, the Telnet connection
will time out after 20 minutes of inactivity. If a connection to a
Telnet session is lost inadvertently, the switch terminates the
session within two hours.