Intel 480T, User Manual

Page: 210 / 367

208
C H A P T E R 1 1 RIP and OSPF
OSPF Timers and Authentication
Configuring OSPF timers and authentication on a per-area basis is
a shorthand for applying the timers and authentication to each
VLAN in the area at the time of configuration. If you add more
VLANs to the area, you must configure the timers and
authentication for the new VLANs explicitly.
Configuring RIP
Table 51 describes the commands used to configure RIP.
Table 51: RIP Configuration Commands
Command Description
config rip add vlan [<name> | all] Configures RIP on an IP interface. If no
VLAN is specified, then
all
is assumed.
When an IP interface is created, per-interface
RIP configuration is disabled by default.
config rip delete vlan [<name> | all] Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are
not reset to their defaults.
config rip garbagetime {<delay>} Configures the RIP garbage time. The timer
granularity is 10 seconds. The default setting
is 120 seconds.
config rip routetimeout {<delay>} Configures the route timeout. The timer
granularity is 10 seconds. The default setting
is 180 seconds.