Intel 480T, User Manual

Page: 189 / 367

C H A P T E R 1 0 IP Unicast Routing
187
Table 46 describes the commands used to configure the IP route
table.
Table 46: Route Table Configuration Commands
Command Description
config iproute add <ipaddress> <mask>
<gateway> <metric> {unicast-only |
multicast-only} Adds a static address to the routing table. Use
a value of 255.255.255.255 for
mask
to
indicate a host entry
config iproute add blackhole <ipaddress>
<mask> {unicast-only | multicast-only} Adds a
blackhole
address to the routing
table. All traffic destined for the configured IP
address is dropped, and no Internet Control
Message Protocol (ICMP) message is
generated.
config iproute add default <gateway>
{<metric>} {unicast-only | multicast-only} Adds a default gateway to the routing table. A
default gateway must be located on a
configured IP interface. If no metric is
specified, the default metric of 1 is used. Use
the unicast-only or multicast-only options to
specify a particular traffic type. If not
specified, both unicast and multicast traffic
uses the default route.
config iproute delete <ipaddress> <mask>
<gateway> Deletes a static address from the routing table.
config iproute delete blackhole <ipaddress>
<mask> Deletes a
blackhole
address from the
routing table.
config iproute delete default <gateway> Deletes a default gateway from the routing
table.
config iproute priority [rip | bootp | icmp |
static | ospf-intra | ospf-inter | ospf-as-external
| ospf-extern1 | ospf-extern2] <priority> Changes the priority for all routes from a
particular route origin.
disable iproute sharing Disables load sharing for multiple routes.