IBM RS/6000 Enterprise Server M80, Service Manual

Page: 279 / 567

Table 7. Service Processor Error Codes (continued)
Error Code Description Action/
Possible Failing FRU
406E 00A2 Scan control routines detected service
processor firmware (processor runtime
diagnostics) fault
Check for system firmware updates
Location: U0.1-P1/Y1
406E 00A3 Scan control routines detected memory
plugging fault
All pluggable memory
406E 00A4 Scan control routines detected application
caused fault
Application software
406E 00A5 Scan control routines detected invalid system
configuration
Verify system components are supported and
properly installed.
406E 00A6 Scan control routines detected no usable
memory
1. Ensure that CEC memory is properly
installed.
2. If more than one DIMM is called out, go
to the service processor Memory
Configuration/Deconfiguration Menu to
verify memory DIMMs state. See
″
Memory Configuration/Deconfiguration
Menu
″
on page 374 for more information.
406E 00A7 Scan control routines detected hardware
problem
Go to minimum configuration and also run
CEC minimum configuration
406E 00B0 Scan control routines detected bus controller
lock-unlock failure
RIO bus adapter
Location: U0.1-P1.1
406E 00B1 Scan control routines detected bus controller
failure
RIO bus adapter
Location: U0.1-P1.1
406E 00B3 Scan control routines detected clock fault 1. Clock card
Location: U1.1-P1.1.1
2. CEC RIO bus adapter
Location: U1.1-P1.1
406E 00B7 Scan control routines detected insufficient
hardware resources to continue IPL
This error code appears after the initial
testing by the service processor firmware on
the CEC was completed correctly, but a
problem occurred when the firmware tried to
communicate outside the CEC. Suspect a
problem with the RIO interface, either cables
or adapters.
406E 0200 Scan control routines detected memory riser
card fault
Memory riser card 1
Location: U1.1-P1-M1
406E 0201 Scan control routines detected memory
DIMM fault
Memory DIMM 1, riser 1
Location: U1.1-P1-M1.1
406E 0202 Scan control routines detected memory
DIMM fault
Memory DIMM 2, riser 1
Location: U1.1-P1-M1.2
406E 0203 Scan control routines detected memory
DIMM fault
Memory DIMM 9, riser 1
Location: U1.1-P1-M1.9
406E 0204 Scan control routines detected memory
DIMM fault
Memory DIMM 10, riser 1
Location: U1.1-P1-M1.10
406E 0205 Scan control routines detected memory
DIMM fault
Memory DIMM 17, riser 1
Location: U1.1-P1-M1.17
406E 0206 Scan control routines detected memory
DIMM fault
Memory DIMM 18, riser 1
Location: U1.1-P1-M1.18
Chapter 5. Error Code to FRU Index
261