IBM 4332-004 - InfoPrint 40 B/W Laser Printer, User Manual

Page: 238 / 296

8.
If the problem involves spots or streaks, print several test pages to clean
out contamination.
9.
If the problem is with complex graphics or images and the message MRT
COMPRESSION displays, try changing the PAGEPROT menu item to ON.
This item can be individually set in specific data stream menus (PCL
Menu, PS Menu, or IPDS Menu.) You may also need more memory. See
“Memory Requirements” on page 8 for information about memory
requirements.
10. If you have an EDGE-EDGE setting set to ON, set it to OFF. EDGE-EDGE
can be found on the following menus:
v
“PCL Menu” on page 106
v
“PS Menu” on page 110
v
“Coax Setup Menu” on page 134
v
“Twinax Setup Menu” on page 136
v
“IPDS Menu” on page 111
11. Consider replacing the fuser. See “Changing the Usage Kit” on page 152.
Print Is Too Light
Possible Causes Actions You Should Take Print Sample
Economy mode is set on. Make sure economy mode is not set.
Check your print driver settings and
also see “Configuration (Config)
Menu” on page 102.
Density is set too low. Reset it to a higher value if
necessary. See “Configuration
(Config) Menu” on page 102.
There is moisture in the
paper. Load fresh, dry paper.
The toner cartridge is low
on toner. Replace the toner cartridge. See
“Changing the Toner Cartridge” on
page 144.
The toner cartridge is
damaged or life exceeds
23,000 pages. Replace the toner cartridge. See
“Changing the Toner Cartridge” on
page 144.
226
Infoprint 32 and Infoprint 40: User’s Guide