IBM 4332-004 - InfoPrint 40 B/W Laser Printer, User Manual

Page: 147 / 296

Coax Setup Menu
Item Value Description
PORT TMEOUT nnn Specifies the number of seconds the printer waits for data
before it determines there is no more data to receive for the
job. The printer then checks other installed attachments, and
will switch to attachments with jobs waiting. nnn can be
from 0 to 255. The default is 90 seconds. 0 dedicates the
printer to the coax attachment (the printer will not accept
data from other attachments).
Note:
If you change PORT TMEOUT from 0 to another
value, you must submit another coax job or power off and
then power on the printer before the new value can take
effect.
IRQ TMEOUT nn Specifies when an IRQ (intervention required) timeout is
sent. This tells the printer how long to wait for an
intervention required condition to be corrected before
notifying the host of the error. nn can be from 0 to 20
minutes. The default is 1 minute. 0 specifies to never send
an IRQ timeout.
HLD TMEOUT nn Specifies the hold timeout value. This value tells the printer
how long to wait if the printer is offline for an intervention
required condition to be corrected. After this time elapses,
the host is notified of the error, unless no other coax jobs
are pending. If no other coax jobs are pending, no HLD
TMEOUT error notification is sent.
nn can be from 0 to 20 minutes. The default is 1 minute. 0
specifies to never send a hold time out.
BUSY TMEOUT nnn Specifies the busy timeout value. This specifies the amount
of time to wait (when the printer is connected to multiple
ports) for control to be returned to the coax attachment,
before notifying the host. nnn can be from 0 to 999 minutes.
The default is 20 minutes. 0 specifies to never send a busy
timeout.
EDGE-EDGE OFF*
ON Turns edge-to-edge printing on or off.
v
OFF—the printer maintains a border of 4 mm on all four
paper sides.
v
ON—The printer allows printing up to the physical page
size.
Notes:
1. To prevent toner from contaminating the printer, IBM
recommends leaving EDGE-EDGE set to OFF for coax
printing; use ON only when necessary.
2.
The Coax Setup Menu item EDGE-EDGE applies to SCS
data only. To specify edge-to-edge printing for IPDS
data, use the EDGE-EDGE item on the IPDS Menu.
Chapter 6. Operator Panel Menus
135