IBM 4332-004 - InfoPrint 40 B/W Laser Printer, User Manual

Page: 148 / 296

Coax Setup Menu
Item Value Description
EAB ENABLE*
DISABLE Enables or disables the extended attribute buffer support.
Note:
The EAB menu item also enables or disables the
ability to print IPDS jobs over the coax attachment.
BUFFERSIZE 960
1920*
2560
3440
3564 Specifies the buffer size in bytes.
EARLY COMPL ON*
OFF Turns early print completion on or off for non-IPDS data
sent over the coax attachment. To turn early print
completion on or off for IPDS data, use the EARLY COMPL
item on the IPDS Menu.
v
ON—sends an “order complete” as soon as data is
received.
v
OFF—waits until the print job is physically complete to
send “order complete.”
Twinax Setup Menu
Use the Twinax Setup Menu to configure the twinax attachment. The
following table describes the settings you can change from the Twinax Setup
Menu. An asterisk (*) next to a value in the table indicates the factory default.
The Twinax Setup Menu appears only if you have the twinax network
interface card installed.
Notes:
1.
To select a new value, press the Enter key when the value is displayed in
the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that it is now active.
Important!
If you change SCS ADDR or IPDS ADDR, you must power off
the printer, wait ten seconds, and then power on the printer for the new
value to take effect.
2. For more information about configuring the twinax attachment, see
Twinax/Coax Configuration Guide.
3. If you are unfamiliar with using the operator panel to work with menus,
please read “Using the Operator Panel Keys” on page 23 and “Navigating
Menus” on page 24 before continuing.
136
Infoprint 32 and Infoprint 40: User’s Guide