IBM 4332-004 - InfoPrint 40 B/W Laser Printer, User Manual

Page: 149 / 296

Twinax Setup
Menu Item Value Description
SCS ADDR OFF*
n The twinax hardware address of the SCS port. n can be
from 0 to 6.
Notes:
1. SCS ADDR and IPDS ADDR cannot be set to the same
value.
2. If you change SCS ADDR or IPDS ADDR, you must
power off the printer, wait ten seconds, and then power
on the printer for the new value to take effect.
3. When the IPDS SIMM is installed, the printer can act as
two separate printers on the same twinax port. (The
printer cannot be attached to two different twinax
systems using the same twinax card.) One “printer”
prints SCS data to one address (SCS ADDR), and the
other prints IPDS to another address (IPDS ADDR).
IPDS ADDR OFF*
n The twinax hardware address of the IPDS port. n can be
from 0 to 6.
Notes:
1. SCS ADDR and IPDS ADDR cannot be set to the same
value.
2. If you change SCS ADDR or IPDS ADDR, you must
power off the printer, wait ten seconds, and then power
on the printer for the new value to take effect.
3. When the IPDS SIMM is installed, the printer can act as
two separate printers on the same twinax port. (The
printer cannot be attached to two different twinax
systems using the same twinax card.) One “printer”
prints SCS data to one address (SCS ADDR), and the
other prints IPDS to another address (IPDS ADDR).
EDGE-EDGE OFF*
ON Turns edge-to-edge printing on or off.
v
OFF—the printer maintains a no-print border of 4 mm on
all four paper sides.
v
ON—The printer allows printing up to the physical page
size.
Notes:
1.
To avoid toner contaminating the printer, IBM
recommends leaving EDGE-EDGE set to OFF for twinax
printing; use ON only when necessary.
2. The Twinax Setup Menu item EDGE-EDGE applies to
SCS data only. To specify edge-to-edge printing for IPDS
data, use the EDGE-EDGE item on the IPDS Menu.
Chapter 6. Operator Panel Menus
137